You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Next »

Switches: settings for USB Firmware, FPGA bitstream programming,  Power Supply  and reset.

Organized by modules

TE0300 is provided with the following slide switches:

TE0320 is provided with the following slide switches:

TE0630 is provided with the following slide switches:

Organized by types

EEPROM switch

EEPROM enabled: a connection between EEPROM and USB FX2 microcontroller exists.

EEPROM disabled: a connection between EEPROM and USB FX2 microcontroller doesn't exist.

EEPROM switch:

For all the switches above EEPROM is enabled when the switch is ON and the EEPROM is disabled when the switch is OFF.

EEPROM switch is ON by default, to allow the USB FX2 microcontroller to read the serial EEPROM and enumerate as a custom/specific USB device.

Power Rails Configuration

Power Rails Configuration:

Master Reset

Master Reset (aka Reset Line):

  • TE0300: S2
  • TE0320: S1D
  • TE0630: it doesn't exist as a switch but only as a button.

FPGA Configuration selection

FPGA Configuration selection (SPI+Jtag or only JTAG):

  • TE0300: S4
  • TE0320: it doesn't exist as a switch
  • TE0630: it doesn't exist as a switch

FPGA Configuration selection (Mode Pins):

  • TE0300: they doesn't exist as switches.
  • TE0320: S1[B:C], for more information.
  • TE0630: they doesn't exist as switches.

 

  • No labels