Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Note
Direct SPI configuration is supported only up to Xilinx iMPACT version 11.x. See Xilinx AR#36156. Available only for TE0300 (through J3 SPI interface) and TE0320 (through B2B connection).
Info
For further information about direct (pure SPI) in-system programming of SPI Flash memories, please see Xilinx Application Note XAPP951 "Configuring Xilinx FPGAs with SPI Serial Flash".

You must follow the procedure below.

Make sure that reset swith is enabled:

  • S2 is switched to "Reset" (OFF) during programming (TE0300 module);
  • S1D is switched to "Reset" (ON) during programming (TE0320 module).

Connect the host computer to the micromodule through both the SPI flying leads cable and the USB cable.

...

Scroll pdf title
title"Program Succeeded"

Switch S2 Move Master Reset switch back to the "Run" position. Make sure that reset swith is disabled:

  • S2 is switched to "Run" (ON) after programming (TE0300 module);
  • S1D is switched to "Rin" (OFF) after programming (TE0320 module).

In case you uploaded the test design, you should see the on-board led blinking at 0.5 Hz.