Page History
Optionen im Plattformdesigner, die sinnvoll wären eingestellt zu werden:
USB Controllers
SPI Controllers
Enable MPU Interrupts auswählen, dann muss das verbunden werden oder Exportiert, wohin / womit?
Setup of your own project
...
Quartus places the folder db, two files HPSexample.qpf and HPSexample.qsf into the project folder
and the setup is accomplished.
Plattform Designer
This programm creates inside the project folder the following
HPSexample.sopinfo -
PlattformEditorHPS.qip
files and
(hps_isw_)handoff folder.
The contains paths for all of the files for an IP core, the
- Use the Plattform Designer to configure the resources needed to boot the HPS
(System Memory and SD card access)
...
Tab Peripheral Pins:
Quad SPI Flash Controller - QSPI pin: HPS I/O Set 0
SD/MMC Controller - SDIO pin: HPS I/O Set 0 - SDIO mode: 4-bit Data
USB Controllers
SPI Controllers
UART Controllers - UART0 pin: HPS I/O Set 0 - UART0 mode: no Flow Control
I2C Controllers - I2C0 pin: HPS I/O Set 1 - I2C1 pin: HPS I/O Set 0Can Controllers
Tab HPS Clocks:
As is / Accept the default values (for both subtabs)
...
The Hardware Description language file is obtained by pressing Generate HDL in the bottom right corner of the
window.
A new window opens, - Generation. In this window, under Synthesis, select via Dropdown Menu in which
Hardware Language your HDL will be created, Verilog or VHDL, check Create block symbole file (.bsf) and
uncheck Create timing and resource estimate... .
...
Close the Plattform Designer by pressing Finish. A notification appears, reminding to add files into the project,
press OK.
FRAGE: Enable MPU Interrupts auswählen, dann muss das verbunden werden oder Exportiert, wohin / womit?
Notification opens, add file PlattformEditorHPS.qip / .sip (Not Generated, uncheckt simulate)
To add the file(s), open a new dialogue window via Project → Add/Remove Files in Project ... .
...
Overview
Content Tools