Table of contents
CPLD Access
Remove TEC0850 from Backplane
- Set DIP S1:1 to OFF
- Connect 12V Power source
- Connect Arrow USB Programmer
CPLD Programming
- Run Quartus Prime Lite Edition
- Click to run "Programmer"
- If you see "No Hardware" :
Click "Hardware Setup..." and select "Arrow-USB-Blaster" - Press and select *.pof file to program.
- Check "Program/Configure" checkboxes
- Press
- After the end of programming, progress bar should show you
Available CPLD Firmware
- - Firmware description
- TEC0850 MAX10 - SMB Firmware
Overview
Content Tools