You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 18 Next »

TE0320 is provided with 4 system DIP slide switches as shown in Figure 32: S1A, S1B, S1C, S1D.

DIP slide switches S1[A:D].

Please note the 4 switch labels are on one side and the <ON> label is on the opposite side.
DIP slide switches S1[A:D] condition the value of some system signals as described in the table below.

switch

S1 label

signal name

<OFF>

<ON>

S1A

1

EEPROM serial data connection to USB FX2 microcontroller

the USB FX2 microcontroller CANNOT read / write the serial EEPROM

the USB FX2 microcontroller can read / write the serial EEPROM

S1B

2

M2

mode pin M2 = 1

M2 = 0

S1C

3

M1

mode pin M1 = 1

M1 = 0

S1D

4

/MR (master reset)

module reset

module running


S1X settings description.

DIP slide switch S1A (EEPROM serial data connection to USB FX2 microcontroller)

DIP slide switches S1A is ON by default, to allow the USB FX2 microcontroller to read the serial EEPROM and enumerate as a custom/specific USB device.

DIP slide switches S1B and S1C (Mode PIN: selection of the way to program SPI Flash)

Mode pins M2 (S1B), M1 (S1C), M0 tell the FPGA how the bitstream will be loaded. See this section for more information.

DIP slide switches S1D (Master Reset of TE0320)

DIP slide switches S1D is OFF by default, to allow the USB FX2 microcontroller and the FPGA to run

  • When DIP slide switches S1D is ON, the TE0320 is in reset state.
  • When DIP slide switch is OFF, the TE0320 is in run (normal) state . If the TE0320 was in reset state before the USB FX2 microcontroller reload the serial EEPROM in RAM and the FPGA reload the bitstream from SPI Flash.
  • No labels