You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

Table of Contents

Overview

Module Overview


Power supply

Single 5V power supply with minimum current capability of 2.5A is recommended to operate the board.

DIP-Switches and Push Buttons

There is a switch S1 which is connected to RESET signal which resets the system entirely.

Signal

DesignatorB2BActive Level

RESET

S1

J2-7

Active High
DIP Switchs and Push Buttons

There are no DIPs on TE0728. In case of TE0790 (XMOD) usage, see power supply section.

LEDs

There are three user LEDs which can be used for variant purposes.

DesignatorColorConnected toB2BActive LevelNote
D1-ARedMIO48J2-30Active high
D1-BYellowMIO49J2-38Active high
D1-CGreenMIO50J2-36Active high
On-board LEDs

JTAG/UART

JTAG and UART is possible over miro USB connector.

miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).

Reference Designs

Notes

  • No labels