You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 23 Next »

Table of Contents

Overview

Board Overview
  1. Barrel Jack Power Supply
  2. XMOD JTAG Adapter
  3. SD card holder
  4. Reset
  5. Boot mode Jumper
  6. LEDs (R,Y,G)
  7. Ethernet Socket

Power supply

Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board. 


DIP-Switches and Push Buttons

There is a switch (S1) which is connected to RESET signal, it resets the system entirely.

Signal

DesignatorB2BActive Level

RESET

S1

J2-7

Active High
DIP Switches /Push Buttons

There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.

Jumpers

DesignatorConnected toB2BNote
J4Boot_RJ2-11Open: QSPI
Short: SD Card
Jumpers

LEDs

There are three user LEDs on the carrier TEB0728 which can be used for variant purposes.

DesignatorColorConnected toB2BActive LevelNote
D1-ARedMIO48J2-30Active high
D1-BYellowMIO49J2-38Active high
D1-CGreenMIO50J2-36Active high
Carrier LEDs

Furthermore, there are two user LEDs on module TE0728.

DesignatorColorConnected toActive LevelNote
D4GreenBank33 pin V18Active high
D8RedMIO7Active high
Module LEDs

JTAG/UART

JTAG and UART connections are available through XMOD JTAG adapter. For more information refer to TE0790.

Designator

Connected to

B2B Pin

XMOD Header JB1DirectionNote
UART TxdMIO52J2-15JB1-3InputTransfer
UART Rxd MIO53J2-16JB1-7OutputReceive
UART

Reference Designs

Notes


  • No labels