Table of Contents
Overview
Basic instructions to work with TEI0022.
Functionality of buttons, DIP switches, LEDs depends on CPLD Firmware.
Board Overview
Board Overview
| Number | Note | Number | Note |
|---|---|---|---|
| 1 | 15 | ||
| 2 | 16 | ||
3 | 17 | ||
| 4 | 18 | ||
| 5 | 19 | ||
| 6 | 20 | ||
| 7 | 21 | ||
| 8 | 22 | ||
| 9 | 23 | ||
| 10 | 24 | ||
| 11 | 25 | ||
| 12 | 26 | ||
| 13 | 27 | ||
| 14 | 28 |
Power supply
Single ??V power supply with minimum current capability of ??A is recommended to power on the board.
DIP-Switches and Push Buttons
There is a switch (S??) which is connected to RESET signal, it resets the system entirely.
Signal | Designator | B2B | Active Level |
|---|---|---|---|
DIP Switches /Push Buttons
There is no DIPs on TExxxx. In case of TE0790 (XMOD) usage, see DIPs mode.
Jumpers
| Designator | Connected to | B2B | Note |
|---|---|---|---|
| Boot_R | Open: | ||
| Short: |
Jumpers
LEDs
There are three user LEDs which can be used for variant purposes.
| Designator | Color | Connected to | B2B | Active Level | Note |
|---|---|---|---|---|---|
Carrier LEDs
| Designator | Color | Connected to | Active Level | Note |
|---|---|---|---|---|
Module LEDs
| Designator | Color | Connected to | Active Level | Note |
|---|---|---|---|---|
Carrier LEDs
JTAG/UART
JTAG and UART connections are available through mini USB connector.
| Designator | Connected to | B2B Pin | XMOD Header JB? | Direction | Note |
|---|---|---|---|---|---|
UART
Reference Designs
Notes
Overview
Content Tools